Air Shovel 150 Air Shovel Round Handle Set Air Hammer Air Shovel Brake Pads Pneumatic Pick Pneumatic Shovel Hammer Tire Repair .Sturdy Time Proof

150 air shovel is suitable for sand removal of small castings and beveling before welding. and welding slag after welding. The flat weld scar and rust removal head can be used for rust removal of uneven surfaces of mechanical equipment. Rust device. simple structure and high efficiency.

Remove the rust on the car muffler pipe. the curling of the metal sheet metal. and the welding slag. Automobile industry exhaust pipe. sheet metal use and decoration construction. wall slotting and embedding. Cement plant concrete plant equipment and filling trucks knock down cement blocks and so on.

It is suitable for baking paint. auto repair. hardware. ceramic lighting. stone processing. wall treatment (construction industry). craft carving. polishing and other operations.

The 150 air shovel air inlet filter is designed to effectively filter impurities and prevent fines from entering the fuselage and damaging the machine. It can be used only when it is connected to a general air pipe.

The air inlet of the 150 air shovel is also a pneumatic oil filling hole. Please inject 2-3CC of pneumatic lubricating oil before and after use every day. After filling the oil. please let the machine run for a few seconds.

• Use proper pressure air
• For the 150 air shovel. please use the gas with the air pressure in the range of 6.0~8.0KG/CM2. If the air pressure is too low. the working efficiency of the tool will be significantly reduced or even fail to work normally. If the air pressure is too high. although the working efficiency of the tool can be improved. it is easy to damage the internal parts and shorten the life of the tool.
• Use filter
• Moisture. dust. rust and other foreign matter in the compressed air of the 150 air shovel are the main causes of premature aging of pneumatic tool parts. so it is necessary to install a filter. Filter the foreign matter in the air to provide clean and dry gas for the tools. The filter must have sufficient flow and be cleaned frequently. otherwise it will affect the normal operation due to insufficient flow. In addition. after an air compressor has been working for a period of time. a large amount of water will accumulate inside. which must be discharged regularly to ensure that the gas is dry.
• Lubrication of tools
• The 150 air shovel must be regularly and appropriately lubricated to ensure normal and long-term work. The correct lubrication method is achieved through the three-point combination device (water and oil grid). When the air flows through the water and oil grid. it will atomize the lubricating oil in the oil tank. and the choice of lubricating oil is also very important. Using incorrect lubricating oil will cause damage to the tools. Generally. special lubricating oil for pneumatic tools is used. It is strictly forbidden to use concentrated engine oil. If there is no water and oil grid device for the time being. put 3-4 drops of lubricating oil on the air inlet of the tool before and after work every day.
• No-load speed
• 4500 (rmp)
• Air consumption
• 5
• Related Products:chisel set.chisel.hammer drill.jack hammer.hammer drill for concrete.demolition hammer.chipping hammer.rotary hammer.electric hammer.rivet gun.rivet gun kit