AL-460 Power Feed Z-Axis for Milling Machine 450 in-lb Torque. 0-200RPM Table Milling Machine Power Feed 110V.for Bridgeport and Other Knee Type Mills with a 5/8 Diameter Shaft on the End

Specification:

Type: Z-axis power feed

Voltage: 110 V. 50/60 Hz

Rotate speed: 0-200 RPM

Max torque: 450 in-lb

Max feed rate: 650 mm/min

Max return speed: 850 mm/min

Package size: 7.1 x 3.5 x 11.7 INCH

Package weight: 9.04 lb

Package Including:

1 x Power Feed Z-axis for Milling Machine

1 x Copper Gear

2 x Limit Block

10 x Adjusting Shim+1 x Dial Shim

1 x Nominal Diameter 6 Washer

4 x Install Screw

1 x Limit Switch Box

2 x Limit Switch Spring+1 x Handle Spring

1 x Connecting Rod

???Basic Parameters???Z-AXIS POWER FEED Material:Made of aluminum material;Voltage: 110V.50/60Hz;Rotate Speed:0-200 RPM.Max Torque:450in-lb;Max feed rate: 650mm/min; Max return speed: 850mm/min

???High Performance???This Power feed for milling machine is equipped with safety feature to protect transmission gear and electronic components as to meet the requirements of ergonomics.The two gears fed by this power table are designed to not mesh and wear at the same position. which not only increases durability and service life. but also reduces noise over time.

???Easy to Use???Small volume and easy installation.noiseless direction changes. Fit almost any horizontal knee type milling machine and other small machinery.

???Excellent Speed Control???The speed can be adjusted manually or automatically in the entire range according to the requirements of the operator.

???Wide Application & Customer Service???The power table feed is suitable for most vertical knee mills machine. such as Bridgeport. Precision Matthews. Grizzly. Enco. Jet. Sharp. Acer. Webb. GMC. Kent. Clark. Supermax. etc.NOTE:We are very sorry for a few product damages caused by the long-distance transportation. so no matter the product you received is damaged or encountered any problems during use. please contact us in time. and we will do our best to solve them for you.